Total Length: Sets the accumulated size of all scatter nodes in percent. After you’ve successfully installed a plugin or extension, if you can’t locate it, go to My Exchange, select the extension, and navigate to the section Where to find it. Follow the onscreen instructions to complete the install.
#How to install plug in multi scatter install#
Speed: Sets the same animation duration for each bar. Select Buy for these plugins and then follow the onscreen instructions to install them. Relative Length: If activated, each scatter node will have its own 100% size (e.g. Horizontal Alignment: Sets horizontal orientation to left, center or rightĬontainer: Drag drop the container which will be used for the scatter nodes.ĭataZ Position: Use DataZ for Z-axis positioning.ĭataZ SizeX: Z Values influence X scaling.ĭataZ SizeY: Z Values influence Y scaling.ĭataZ SizeZ: Z Values influence Z scaling.Ĭenter Container: Centers each translated container.įit Width: Considers the width of the scatter node containers which means that the containers do not reach outside of the specified range.Īnimate Position: Sets the translation type: None: no animation, Y: animates the container along the Y axis (suggestion: Scale Y + DataLabel for BarChart alike labeling).Īnimate Scaling: Sets the scaling type: None: no scaling at all, XYZ: linear scaling in all directions, Y: scales in y direction only (->BarChart) Transfer Mode: Sets string- or array-based data transfer.ĭata Delim.: Defines the value separator sign(s).ĭataX, -Y, -Z Fit: Enables data normalization.ĭataX, -Y, -Z Scale: Scales input by the selected factor.ĭataX, -Y, -Z Offset: Adds an offset to the incoming data.ĭataX, -Y, -Z Auto Scale: Enables automatic data normalization.ĭataX, -Y, -Z Detect Limits: Detects minimum and maximum of all values and scales them to adjusted Start and Stop.ĭataX, -Y, -Z Threshold: Adds a definable offset to the detected limit.ĭataX, -Y, -Z Start: Lower Auto Scale edge.ĭataX, -Y, -Z Stop: Upper Auto Scale edge. DataZ is the default input parameter for Z values. DataY is the default input parameter for Y values. DataX is the default input parameter for X values. Use Inactive memory to not forward any values via Shared Memory. Shared Mem.: Changes between Scene-, Global- and Distributed-Shared Memory.